PCI-TMC12A 12-channel Counter/Timer + Dig I/O Board Measurement Systems

PCI-TMC12A 12-channel Counter/Timer + Dig I/O Board

$314

The PCI-TMC12A is a PCI-Bus general purpose counter/timer and digital I/O board.

It provides tweleve channels of 16-bit counter/timer. Two internal clock sources (8M / 1.6M and 0.8M / 80K) are selected by jumper. Four 8254 chips provide a variety of powerful counter / timer function modes to match your industrial and laboratory applications.

This card can be installed in a 32-bit 5 V PCI bus and can support "Plug & Play".

Includes one CA-4002 D-Sub connector.

PCI-TMC12A 12-channel Counter/Timer + Dig I/O Board

Features

On board four 8254 timer / counter chips

Twelve independent 16-bit timer/counter

Twelve external clock input

Twelve external gate control input

Twelve timer / Counter Output

16-bit Timer / Counter can be cascaded to 32 / 48 -bit

Gate input can be from external or previous timer / counter output

Four interrupt sources (COUT3, COUT6, COUT9, COUT12)

Two internal clock source (8M/1.6M,0.8M/80K)

16-channel of D/I and D/O

All signals are TTL compatible.

Software

Toolkit for DOS

Toolkit for Windows 95/98

Toolkit for Windows NT

Toolkit for Windows 2000/XP

LabVIEW toolkit for Windows

Toolkit for OCX 95/98

Toolkit for OCX NT

Driver for LINUX

Specifications

Specifications

All I/O is TTL compatible

Input Logic high voltage : 2.0V min./5.0V max.

Input Logic low voltage : -0.5V min./0.8V max.

Output Sink Current : 24mA max.

Output Source Current : -15mA max.

I/O connector : One 37-pin D-sub female
two 20-pin ribbon male

Power Requirements : +5V@500mA

Operating temperature : 0~60°C

Storage temperature : -20~80°C

Humidity : 0~90% RH, non-condensing

Dimensions : 150mm x 105mm

Technical

Dig I/O Shortform Catalogue

Applications

Event counting

Wave Generator

Frequency Measurement

Pulse Width Measurement

Time-delay generation

Recommendations

Units supplied with a CA-4002 37-pin connector and shroud.

To break out Digital Channels to PC Rear Panel

ADP-20/PCI Slot Extender (Rear Panel with dual 20-pin flat-cable connector and internal cables to Card)

For Straight Connection to screw terminals:

DN-20 I/O connector block with 2off 20pin headers (DIN-Rail Mounting) supplied with CA-2010 (20 way flat cable - 1m)
DN-37 37 pin D-sub to DIN Rail Mounting Screw Terminal board (via 1m cable)
DB-37 Direct Connection - 37 pin D-sub conn. to screw terminals

To Isolated Inputs/Relay Outputs:

DB-16P 16-channel Bi-direction Isolated Input Board; includes 1x CA-2010 (20-pin Flat Cable 1m)
DB-16R 16-channel Relay Board; includes : CA-2010 (20-pin Flat Cable 1m)